$ 279.99 $ 336.00
The Headlight is a unity gain guitar amp selector designed to easily integrate onto a pedalboard and provide the ability to switch between as many as four amplifiers with a single footswitch.
The Headlight has a compact footprint that will fit on any pedalboard, but it's still powerful enough to drive up to four amplifiers without sacrificing on tone. The input features a class-A buffer along with Drag Control load correction that allows you to optimize the impedance for your pickups and recreate the feel of plugging your guitar directly into an amp. Custom transformers isolate the outputs to prevent buzz and hum from ground loops, with ground lift switches to further alleviate noise problems. Should you really want to get loud, the mute footswitch can be configured as an 'all on' switch, activating all four amp outputs simultaneously.
Use the Headlight to switch between four stage amps to create the ultimate setup for clean, crunch, overdrive and power solo! Simply depress the selector footswitch to select the amp you want. Super bright LEDs let you know which amp is active. Use the mute footswitch for quiet on-stage tuning.
Connect your two amps using outputs 1 and 2 and select between them using the right-hand footswitch. Set the left-hand footswitch to ALL-ON and when depressed, both amps will play. The isolation transformers will prevent buzz and hum from ground loops when both amps are on.
Using the Headlight you can feed both direct boxes and amplifiers. The outputs from the direct boxes can be sent directly to the mixer and stage amps can be mic'd.
SPECS
Specifications | ||
---|---|---|
Audio circuit type: | Classic Class-A FET | |
Frequency response: | 30Hz - 30kHz | |
Dynamic range: | 116dBu | |
Gain: | -0.5dBu | |
Clip Level: | +7dB | |
Total harmonic distortion: | 0.01% | |
Intermodulation Distortion: | 0.02% | |
Phase Deviation: | -1.35° @ -20dBu / 1kHz | |
Input Impedance: | 20k to 1MΩ | |
Output Impedance: | 1kΩ | |
Noise: | -112dBu | |
Maximum Input: | +8dB | |
Features | ||
180° polarity reverse, Ground lift, Drag Control | ||
Input Connectors: | 1/4" | |
Output Connectors: | 1/4" | |
General | ||
Construction: | 14-Gauge Steel | |
Size (L x W x D): | 5" x 4.7" x 2" | |
Weight: | 2lb | |
Shipping size (L x W x D): | 6.5" x 5.1" x 2.5" | |
Shipping weight: | 2.4lb | |
Power: | 9V adaptor / 80mA (Center Pin Negative) | |
Conditions: | For use in dry locations only between 5°C and 40°C |
$ 184.99 $ 259.00
The RocknRoller® Multi-Cart® R10RT is outfitted with rugged, foam-filled no-flat 10" rear wheels and 5" front swivel casters that will allow you to move massive amounts of gear quickly and easily. The R-Trac® tires ride smoothly with excellent traction, similar to pneumatic tires, but without the hassle of upkeep or repair. The patented 8-in-1 cart can transform easily to adjust to various load sizes, allowing you to move large amounts of gear in no time at all. Extending from 34" to 52" in length, the R10RT has a weight capacity of 500lbs, but also folds small for storage or transport in a vehicle. The textured powder coated steel is durable and also reduces slippage during transport.
Popular Uses:
DJ & Live Sound, Film & TV Production, Location Sound, Facility Maintenance, General Industrial, General Contracting, Electrical Contracting, Wedding Photography, Live Performance, Drums & Percussion, HVAC Contracting, Sports, Scientific/Field Study/Research, Delivery Vans, Pet Shows, Trade Shows
Specifications:
RocknRoller® Multi-Cart® 8-in-1 Equipment Transporter - Model R10RT
Additional specifications:
Tubing gauge: 16 gauge (0.065" wall)
Tubing size on main frame: .75" and 1" square steel tube
19mm axle
Polypropylene Hub with Polyurethane Foam tires
$ 159.99 $ 204.00
The RocknRoller® Multi-Cart® R6RT is outfitted with rugged, foam-filled no-flat 8" rear wheels and 4" front swivel casters that will allow you to move massive amounts of gear quickly and easily. The R-Trac® tires ride smoothly with excellent traction, similar to pneumatic tires, but without the hassle of upkeep or repair. The patented 8-in-1 cart can transform easily to adjust to various load sizes, allowing you to move large amounts of gear in no time at all. Extending from 28" to 42.5" in length, the R6RT has a weight capacity of 500lbs, but also folds small for storage or transport in a vehicle. The textured powder coated steel is durable and also reduces slippage during transport.
Popular Uses:
Facility Maintenance, Household, Warehouse & Storage, General Contracting, Electrical Contracting, Wedding Photography, Live Performance, Guitar & Bass, Drums & Percussion, HVAC Contracting, Scientific/Field Study/Research, Delivery Vans, Pet Shows, Trade Shows, Sales Representative
Specifications:
RocknRoller® Multi-Cart® 8-in-1 Equipment Transporter - Model R6RT
Additional specifications:
Tubing gauge: 16 gauge (0.065" wall)
Tubing size on main frame: .75" and 1" square steel tube
19mm axle
Polypropylene Hub with Polyurethane Foam tires
$ 29.99
The PSA series is the recommended power supply for products including all new BOSS Compact and Twin pedals, Multi-effects and more.
$ 99.99 $ 101.90
CB-CS2 Carrying Case for CUBE Street EX made with water-repellent material.
$ 54.99 $ 67.18
This keyboard pedal features a slip-proof rubber plate that secures it in place during performances on hardwood or metal stage surfaces. The pedal is equipped with a 7.2' extended cable, good for use in stacked multi-keyboard setups, and is compatible with half-damper capable keyboards, while also serving as a standard pedal switch.$ 29.99 $ 30.60
The Roland DP-2 Damper Pedal acts as amomentary footswitch for nonlatch footswitch operations such as sustaining notes on electronic keyboards. Black.$ 175.00
**This item is used and in good condition. Very light cosmetic wear can be seen. The price has been adjusted accordingly.
Roland KC-550 Replacement Speaker for Keyboard Amplifier - 15" / 8 ohm
A previously used item that exhibits signs of cosmetic wear and is fully operational and functions as intended.
$ 189.99 $ 242.62
Available in white or black finish.
$ 99.99
Available in white or black finish.
$ 159.99 $ 223.98
A grand piano pedaling experience.
Combining three pedals into one convenient and clutter-free unit, the Roland RPU-3 Pdeal unit offers a real grand piano pedaling experience. With separate 1/4" outputs for each of its three pedals, the RPU-3 is compatible with keyboards such as Roland's FP-7F and RD-700 series pianos. In addition to providing the same pedal configuration as a grand piano, the RPU-3 also provides hands-free control of various instrument functions, such as the FP-7F's Looper and harmony effects.
$ 139.00
**Case has scratches on both sides **
Sold Out $ 69.99
$ 34.99
Shure's innovative A56D Microphone Drum Mount sets a new standard for versatility. Compact in design, the A56D can be used in a multitude of positions for accurate microphone placement. Live or in the studio, this universal clamp can be mounted virtually anywhere, including drum rims and racks, microphone stands, and cymbal stands. You'll reduce the stage clutter associated with traditional mic stand set-ups.
Designed with captive parts to prevent the loss of individual pieces, the A56D mic mount is small, secure, and sturdy, and can be used with any standard microphone, making it a great tool for both musicians and sound engineers.
$ 599.00 $ 749.00
Cardioid condenser microphone delivers a smooth, neutral sound reproduction with full character and consists of a microphone, a padded, zippered carrying bag, and a swivel mount.
An embossed single-diaphragm, side-address, cardioid condenser microphone for highly critical studio recording and live sound productions. The Shure KSM32 offers an extended frequency response for an open, natural sounding reproduction of the original sound source.
Performance Characteristics
Applications
Some typical applications for the KSM32 are listed below. Microphone use, however, is a matter of personal taste. The KSM32 may be used for a variety of applications other than those listed.
Both the acoustic environment and microphone placement have significant effects on the sound obtained when miking a source. You may need to experiment with these variables to achieve the best overall sound for each application.
Sold Out $ 336.00
Available in a striking silver color, the SE425 allows you to hear your music the way it was meant to be heard - the way your favorite artists intended. This is what true-to-life sounds like, when accuracy is important and range is imperative. Welcome to the big time.
$ 49.00
The Supro Dual Footswitch allows players to control the Tremolo, Reverb, Drive, Boost, and channel-switching circuits of any Supro amplifier with ease. Connecting via a 1/4" TRS cable, the Supro Dual Footswitch allows you to turn on and off your onboard amp effects without having to alter tone controls.
MODEL DUAL FOOTSWITCH |
||
Model Name |
SFS2 | |
SKU |
SFS2 | |
Function |
2 Button Footswitch for Supro amps | |
Category 1 |
Utility |
BODY |
||
Finish |
Flat | |
Length (in) |
3 | |
Width (in) |
5 | |
Height (in) |
2 | |
Weight (lbs) |
1 |
$ 159.99 $ 199.00
This case fits Takamine FXC/Classical/New Yorker guitars.
Sold Out
$ 199.00
The Taylor AeroCase is an innovation in guitar storage and transportation. Made with highly durable, yet lightweight materials, the AeroCase offers all the protection of a traditional hardshell guitar case at one-third the weight. This AeroCase is fitted specifically to Grand Concert acoustic guitars.
Model: 5402-54
$ 199.99
$ 175.00
$ 175.00
Brown deluxe case with deep red velvet interior and gold hardware, for Grand Symphony shaped Taylor guitars.- Hard case for Grand Symphony Taylor acoustic guitars
- Brown exterior
- Deep red velvet interior
- Gold hardware
- Internal accessory compartment
- Exterior: Deluxe brown hard case
- Interior: Deep red velvet
- Hardware: Gold
- Weight: 23 lbs
- Dimensions: (L x W x D) 47 x 21 x 8"
$ 189.99